Volvo D12 Specifikace stáhnout pdf (Strana 8)

Volvo Trucks North America, Inc. Date Group No. Page

TSI 8.2003 215 001 8(21)

Installation

Position the camshaft bearing housings on the cylinder

head by observing the factory marks 1–7.

Note: Check that the mating surface is clean under the

bearing housings and that the guide pins are in good

condition. If installing a new cylinder head, also use the

bearing housings supplied with the cylinder head.

T2007126

Fig. 9: Bearing shell halves

C2000508

Fig. 10: Installing the camshaft

Coat the bearing shell halves with clean engine oil and

install them in the bearing housings. Carefully lower

the camshaft into place.

Note: Make sure that bearing shells of the correct size are

installed and correctly positioned in the bearing housing.

Coat the bearing shell halves with clean engine oil and

install them in the camshaft caps. Install the caps on their

respective bearing housings. Hand-tighten the bolts.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 20 21

Žádné komentáře

Volvo D12 Specifikace Strana 8