Volvo XC90 2006 Servisní příručka

Procházejte online nebo si stáhněte Servisní příručka pro Elektronika motorových vozidel Volvo XC90 2006. Volvo XC90 2006 Service manual Uživatelská příručka

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 20
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 0
XC90
Section
Group
Weight(Kg/Pounds)
Year
Month
3
36
2004
02
XC90 2003, XC90 2004, XC90 2005, XC90 2006
R8600882
XC90
Section
Group
Weight(Kg/Pounds)
Year
Month
3
36
2004
02
XC90 2003, XC90 2004, XC90 2005, XC90 2006
R8600882
Installation instructions, accessories
-
Parking assistance module (PAM),
rear
Installation instructions, accessories
-
Parking assistance module (PAM),
rear
©
VolvoCar Corporation, 2004 Printed in Sweden
©
VolvoCar Corporation, 2004 Printed in Sweden
Page 1 of 20
Zobrazit stránku 0
1 2 3 4 5 6 ... 19 20

Shrnutí obsahu

Strany 1 - Page 1 of 20

XC90SectionGroupWeight(Kg/Pounds)YearMonth336200402XC90 2003, XC90 2004, XC90 2005, XC90 2006R8600882XC90SectionGroupWeight(Kg/Pounds)YearMonth3362004

Strany 2 - Page 2 of 20

12R8600893Installing the sensors●Take the 27.5 mm (1 1/16”) diameter hole cutter (P/N 8671170). Install the hole cutter in the holes; with the screw a

Strany 3 - R3904312

15R8600890Installing the sensors● Take the sensors and the cable harness from the kit● Connect the connectors on the cable harness to the connectors o

Strany 4 - Page 4 of 20

19R8601046Installing the sensors●Measure up to drill the lead-in in the upper plate in the rear section on the left and right-hand sides of the cut-ou

Strany 5 - Page 5 of 20

23R8600983Installing the sensorsApplies to all models● Press the large cable harness for the sensors into place in the existing cable duct (1) in the

Strany 6 - Page 6 of 20

27R8903013Installing the sensors● Remove the expanded polystyrene seal on the left-hand side in the rear cross member under the left-hand side floor h

Strany 7 - Page 7 of 20

30R3904972Installing the parking assistance module (PAM) ●Connect the control module to the pre-routed cable harness. Use the black connector from the

Strany 8 - Page 8 of 20

34R3903738Installing the parking assistance module (PAM) and relay Points 34-43 apply to two wheel drive cars up to and including model year -2004 ● P

Strany 9 - Page 9 of 20

37AR850431337BR850431537CR8504316Installing the parking assistance module (PAM) and relay Illustration A shows the removal of the cover for the load s

Strany 10 - Page 10 of 20

39R3904973Installing the parking assistance module (PAM) and relay ●Connect the control module to the pre-routed cable harness. Use the black connecto

Strany 11 - Page 11 of 20

43R3703033Installing the parking assistance module (PAM) and relay ● Take the relay from the kit. Install the relay in position MA1 in the lower front

Strany 12 - Page 12 of 20

Required toolsA0000161A0000162A0000163A0000172R0801579A0801178R8802817R3602786Installation instructions, accessories - Parking assistance module (PAM)

Strany 13 - Page 13 of 20

46D8502226Installing the switchThe switch can be installed in any location.● Remove the switch blank. Install the new switch (1)● Reinstall the surrou

Strany 14 - Page 14 of 20

R3603458R3904312Installation instructions, accessories - Parking assistance module (PAM), rearInstallation instructions, accessories - Parking assista

Strany 15 - Page 15 of 20

Any comments on this publication? Please contact your nearest dealer. Thank you!Publication no: 30660633, Issue: 2004-02 Comments:...

Strany 16 - Page 16 of 20

INTRODUCTION● NOTE! Read through the entire text before carrying out any work.● The front page gives the date of this edition and the edition it repl

Strany 17 - Page 17 of 20

If the SRS warning lamp lights after repairs have been carried out, take the car to an authorised Volvo workshop.C30/S40(04-)/V50/S60/C70(06-)/V70/S80

Strany 18 - Page 18 of 20

1A8800136Installing the sensors●Turn the ignition key to position 0● Disconnect the battery negative lead.●Clean the bumper. Use a mild soap solution.

Strany 19 - Page 19 of 20

4R3100131Installing the sensors● Remove the four pre-punched sections (1) from the insulation panel in the rear cross member●Remove the four nuts hold

Strany 20 - Page 20 of 20

8R8600897Installing the sensors● Pull the ends of the bumper cover away from the body. Pull off the clips (1) at the bottom and continue up along the

Komentáře k této Příručce

Žádné komentáře